📦 HomeKey-ESP32/ rednblkx

Installation Steps

1. Download Firmware

   • Visit GitHub Releases
   • Download the *.firmware.factory.bin file
   • This contains everything you need - no compilation required!

2. Connect Your Hardware

   • Wire your PN532 NFC module to your ESP32 using the default pins
   • Refer to the detailed wiring guide for your specific setup

3. Flash the Firmware

   # Install esptool (one-time setup)
   pip install esptool
   
   # Flash the firmware (replace YOUR_PORT)
   esptool.py --port /dev/ttyUSB0 write_flash 0x0 firmware.factory.bin
   

   Prefer a GUI? Use the browser-based flasher - no command line needed!

4. Initial Setup

   • Connect to the device's WiFi AP (HomeSpan-Setup / homespan)
   • Access the web interface at http://192.168.4.1
   • Configure your WiFi credentials and HomeKit setup code
   • Pair with Apple Home using code: 466-37-726

5. Start Using HomeKey!

   • Hold your iPhone or Apple Watch near the NFC reader
   • Enjoy instant, secure access to your home! 🎉